Adjust the teeth to let go of the carpeting then lift the head and handle and start over using the appropriate.
Can you over stretch carpet.
The longer you wait to correct it the worse it will get.
Step 4 trim excess carpeting.
This will help hold the carpet in the high traction area.
If a carpet has not been properly installed or if it has experienced heavy foot traffic over the years it can be prone to stretching.
It saves on the cost and labor of pulling up and disposing of the existing carpet keeping carpet waste materials out of the landfill.
You should feel the carpet stretch and see wrinkles disappear.
Carpet stretching can be more of a challenge in times like this but we re up for it.
And if the existing carpet was glued down not tacked it can be a huge time saver to lay the new carpet over the old.
This results in it lifting off the floor into lumps which not only look unpleasant but which can also cause tripping and falling.
Look for transition molding that can be nailed in place over the carpet in the doorway.
Press down the cutter to trim off the excess carpet.
On the face of it installing new carpet over the old carpet does have some advantages.
Call us to stretch the ripples out of your carpet.
Between heavy furniture and high foot traffic your carpet will begin to loosen over time leaving you with a frustrating bump in the middle of your living room.
Over stretching carpet isn t a good idea because you will create ripples going the other direction.
If you are stretching carpet over or through doorways you ll need to pick up some additional materials at the hardware or flooring supply store.
Use the kicker to make small adjustments.
Loose carpeting most commonly occurs in older carpeting.
The deepest setting works best for most carpets.
We can stretch the carpet by just moving the furniture a little bit out of the way but it is more time consuming and therefore can be more expensive.
Smaller spans require less pressure.
Place the carpet cutter in the slit.
If it s too easy you re not stretching the carpet enough to remove the ridges.
Push down on the power carpet stretcher lever firmly to get a good stretch.
Make a slit underneath the carpet with your utility knife where you need to trim off excess carpeting.
As you apply more pressure on the lever you ll feel the carpet stretch.
Repeat until the carpet stretches to the wall.
So again only stretch the carpet as much as you need to in order to remover the ripples.
With the help of a few basic tools the re stretch process will bring your carpet back to life looking as good as new in no time.